Leak Detection Equipment – How to Tell If There is a Leak

If you’ve ever laid foot on a property with utility lines or buried sewer pipes, then you know that leak detection equipment is one of the most important tools in your back yard. Even if you have no reason to suspect anything, it never hurts to make sure. Many cities and large businesses will be responsible for many thousands (if not millions) of feet of buried utility lines and pipes, so locating even just a single water leak can be quite a daunting task, particularly for someone who doesn’t have much experience with these types of matters. That’s why there are so many different types of leak detection equipment, ranging from simple hand-held devices to high-tech gadgets. It all comes down to finding the right tool for the job. Click here – https://www.semrad.com.au/products/leak-detection-systems/ttk-australia-water-leak-detection-system/

Finding Leaks With Reliable Leak Detection Equipment

For example, you need to think about where the leak is located before you even begin to think about using leak detection equipment. Remember, not all pipes are the same – some are more likely to have serious leaks, especially if they are older or situated near areas with higher levels of soil pressure or aging concrete. If a leak is located near a water supply or other main source of pressure, then the first thing you should do is check out the local plumbing regulations in your area. In many places, you are required to have specially designed PVC pipe for any water leaks that you find. This is usually a standard piping design, but it is still important to make sure that your specific pipe is acceptable, since it can cost you a lot of money if you have to replace it.

Once you know where the leak is located, you need to get an accurate leak detection equipment or system that can gauge the volume and velocity of the water flow, along with the pressure. After you’ve located the leak or potential leaks, then you can set about performing your routine testing. This could involve performing an environmental leak test, a leak detection test, or even a simple leak test to see if your siding or paint is going bad. The point is to perform as many different tests as you can, because sometimes problems only come to light on one of them. It’s important to run a variety of routine tests to make sure that you are getting the best chance to repair or avoid costly repairs.

Level Switch, Transmitter & Measurement SEMRAD

27e/1-3 Endeavour Rd, Caringbah NSW 2229

(02) 9531 8474

Home